Click image to view full size image
Summary of Final Revisions to USA Toy Testing Standard ASTM F963-11
The requirements and test methods for the Overload and Stability Sections have been clarified.
A definition for "toy seat" has been added.
Flammability: changed the word "should" to "shall" to eliminate the non-mandatory language.
"Packaging film" changed to "plastic film" to be more inclusive and duplicate information deleted in the Test Method Section.
"Resistivity" changed to "resistance" for strings and flying devices.
Jaw entrapment test gauge was modified to add a third dimension; also added a requirement that the gauge has to completely pass through the opening.
Exclusion added for soft filled rattles and teethers.
Exclusions added for constant air inflatable products and juvenile products from the scope of the standard.
Heavy metal requirements have been revised as follows:
total lead in surface coating limit has been reduced from 600 ppm to 90 ppm to be aligned with 16 CFR 1303;
new heavy metal in substrate requirement, equivalent to the European Toy Standard EN71:3, has been added;
new cadmium requirement added for metal components that fit within the small parts cylinder;
total digestion screening is allowed to determine compliance to the soluble requirement and the special soluble extraction requirement for metal small parts;
compositing is allowed when conducting the total digestion test only; and
alternative tests are allowed as long as specific conditions are met (i.e., XRF testing).
A Guidance Annex for the design of bath toys to minimize potential projection hazards has been added.
Changed "flux density" to "flux index" for toys with magnets.
If you have any further question, please you don’ hesitate to contact us, as below:
Company Name: STC (ShangHai) Company Limited
Company Address: No.130, Huashen Road, Waigaoqiao Free Trade Zone, Shanghai, China.
Contact Person: Bluse Xu
Tel: 0086-18721942395
Fax: 0086-21-52198249
Email:xbj0818@yeah.net
QQ: 1294371308
Skype: xbj0818
Summary of Final Revisions to USA Toy Testing Standard ASTM F963-11
